How to Use Roundup Advanced® Ready-To-Use Pump ‘N Go®
For non-selective control of broadleaf and grassy weeds in and around the garden.
Up to 10 Minutes of Continuous Spray! Extendable wand provides greater accuracy without bending over.
HOW TO ASSEMBLE AND USE ROUNDUP ADVANCED® READY-TO-USE PUMP ‘N GO®:
Sprayer assembly:
1. CUT
Carefully cut the zip ties securing the hose and pump handle with scissors. Use caution not to cut the white hose.
2. CONNECT
Unwind hose. Firmly push the connector at the end of the hose onto the spout on the pump, until it locks into place.
3. EXTEND WAND
Lift sprayer wand off bottle. Push the yellow button while pulling out on the wand nozzle tip. Fully extend the wand until the yellow button snaps into SPRAY POSITION. NOTE: Trigger will not function until wand is fully extended and yellow button is visible in the SPRAY POSITION.
4. PUMP
Make sure the handle is screwed on tightly or the bottle will not pressurize. Pump container 25-30 times to pressurize bottle. A full bottle requires fewer pumps than an empty bottle. Pumping to the higher range will provide longer spray duration. After pumping, push the pump down and turn the handle clockwise to lock into carrying position. NOTE: This bottle is designed to expand under pressure and cannot be over-pressurized.
5. SPRAY
Aim wand. Spray by pushing down white trigger with your thumb. Adjust spray pattern by rotating white nozzle tip up to one half rotation. Spray weeds until thoroughly wet.